Wool-combing roller motion: catch and notch-wheel
217 and 218. These are parts of the same movement, which has been used for giving the roller motion in wool-combing machines. The roller to which wheel, F (218), is secured is required to make one third a revolution backward, then two thirds of a revolution forward, when it must stop until another length of combed fiber is ready for delivery. This is accomplished by the grooved heart-cam, C, D, B, e (217), the stud, A, working in the said groove; from C to D it moves the roller backward, and from D to e it moves it forward, the motion being transmitted through the catch, G, to the notch-wheel, F, on the roller-shaft, H. When the stud, A, arrives at the point, e, in the cam, a projection at the back of the wheel which carries the cam strikes the projecting piece on the catch, G, and raises it out of the notch in the wheel, F, so that, while the stud is traveling in the cam from e to C, the catch is passing over the plain surface between the two notches in the wheel, F, without imparting any motion; but when stud, A, arrives at the part, C, the catch has dropped in another notch, and is again ready to move wheel, F, and roller as required.
Only the input is driven; every other part of this model moves by physics (MuJoCo), and its ratios are measured. Run it live, change its parameters, or switch the friction off to see the output stop.
- Modelled as
- Plate 218's half of No. 217's machine, framed as Brown draws it (from the front, caption at the right): the notch-wheel F (eight notches) on the roller shaft H, the lever swinging on H with its stud A below and the catch G pinned to its upper arm and sprung down. The same bodies, joints, contacts and driver as No. 217 (its MJCF but for the model name): the grooved heart-cam wheel behind F is the one driven joint (6 rpm), its groove swings the lever through A, G's tooth in a notch carries F back and forward with the lever, and a projection on the cam wheel's back lifts G out at e so F stands while G passes over its plain rim.
- Measured
- F turns 1.0000 times the lever on the back and the forward strokes. While the catch is lifted, F stands at 0.735, 1.521 and 2.306 rad after the first three turns: one notch (0.785) a turn, less 0.05 of backlash. The catch lifts 0.149 rad. Max penetration 0.03 mm (No. 217's checks, run on this model).
- Notes
- Nos. 217 and 218 are parts of the same movement: this is No. 217's simulation, not a second mechanism, shown on plate 218's parts. It was cross-linked to No. 217 until the plate caption could be set at the right (display.caption), since a bottom caption lay over the cam wheel at any framing that showed F large. Negative control: all contact off → F stands (0.575 rad) while the cam wheel turns.
Film (MP4) · Still (WebP) · Spec (YAML) · Model (MJCF)

Brown's pages: the plate · his description (full size) · the whole book